Standard GRP Anti Slip Stair Tread Covers

Standard GRP Anti Slip Stair Tread Covers

In Stock

Standard GRP Anti Slip Stair Tread Covers are anti slip and corrosion resistant solution to slip hazards on steps, stairways and landings. An affordable, versatile, durable and easy to install solution that can be applied to concrete, steel or wood. Ideal for medium traffic areas.

Versatile and affordable

Slip and corrosion resistant top surface

Easy and quick to install

Suitable for both industrial and commercial use

Building regulations compliant

Non metallic

You may also be interested in:

Quantity

Description

GRP stair covers are a fast, convenient way of providing solid, slip-resistant footing to existing stairs high footfall and heavily worn steps. Our GRP covers feature a contrasting coloured nosing which complies with the UK Building Regulations and those obligations required under the DDA (Disabled Discrimination Act). 

 

How to Use

Preparation

Ensure your stairs are clean, dry, and free from loose material.

If your surface is uneven, ensure you have patch repaired the area before application. SlipGrip stair treads must sit flat down on the surface.

Your stair treads can be trimmed on site if needed. Use a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade. Ensure googles and gloves are worn at all times when cutting is involved. 

Application

  1. Apply a 6mm bead of the high strength gap filling adhesive around the periphery of the underside of the stair tread approximately 25mm in from the edges.
  2. Then, starting from the bottom left corner come up at an angle and then down at an angle, to create a 'peak and a trough' repeat this until you reach the end.
  3. Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive - this will elevate the sheet by approximately 1-1.5mm from the ground.
  4. A firm bond will be achieved in about one hour under normal conditions. Then, secure with mechanical fixings, as below.
  5. Drill two holes on each side of the SlipGrip stair tread cover, one approximately 15mm in from the back edge and 15mm from the side.
  6. The second one should again be approximately 15mm from the side and approx. 10m back from the contrasting nosing (55mm). For larger treads, it may be necessary to have further fixing points in the centre of the tread.

Technical Spec

Service temperature 20℃ to 80℃
Chemical resistant Yes
Cleaning Use of a stiff brush will be sufficient to remove everyday dirt. For stubborn contamination, it is recommended that that a mild detergent is used, then rinsed with cold water

QUESTIONS & ANSWERS

Have a Question?

Be the first to ask a question about this.

Ask a Question