GRP Stair Nosing Fixing Kit

GRP Stair Nosing Fixing Kit

In Stock

A GRP Stair Nosing Fixing Kit from floorsaver to use with Stair Nosing. 

One fixing kit will cover about 15000mm length of stair nosing. To determine the total amount of fixing kits required, calculate the total length of stairs to cover and divide that by 15000mm.

Consists of 310ml mastic adhesive

Comes with 60 stainless steel self tapping screws and 60 rawl plugs

 

You may also be interested in: 

    Preparation

    Ensure your stairs are clean, dry, and free from loose material.

    If your surface is uneven, ensure you have patch repaired the area before application. Standard GRP Anti Slip Stair Nosings must sit flat down on the surface.

    Your stair nosings can be trimmed on site if needed. Use a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade. Ensure googles and gloves are worn at all times when cutting is involved.

    Application

    • Apply a 6mm bead of the high strength gap filling adhesive around the periphery of the underside of the stair nosing approximately 15mm in from the edges.
    • Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive - this will elevate the sheet by approximately 1-1.5mm from the ground.
    • A firm bond will be achieved in about one hour under normal conditions. Then, secure with mechanical fixings, as below.
    • Drill two holes on each side of the stair nosing, one approximately 15mm in from the back edge and 15mm from the side.
    • For larger nosings, it may be necessary to have further fixing points in the centre of the nosing.
            Service Temperature -40°C to +100°C
            Application Temperature +5°C to +40°C
            Final Adhesion Strength 24-48 hours

            QUESTIONS & ANSWERS

            Have a Question?

            Be the first to ask a question about this.

            Ask a Question