GRP Stair Nosings are a fast, convenient way of providing solid, slip-resistant footing to existing stair edges with medium footfall and worn steps. Our GRP Stair Nosings are resistant to swelling, stretching or warping over a wide range of temperatures and physical stresses. 

Preparation

Ensure your stairs are clean, dry, and free from loose material.

If your surface is uneven, ensure you have patch repaired the area before application. Standard GRP Anti Slip Stair Nosings must sit flat down on the surface.

Your stair nosings can be trimmed on site if needed. Use a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade. Ensure googles and gloves are worn at all times when cutting is involved. 

Application

• Apply a 6mm bead of the high strength gap filling adhesive around the periphery of the underside of the stair nosing approximately 15mm in from the edges.
• Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive - this will elevate the sheet by approximately 1-1.5mm from the ground.
• A firm bond will be achieved in about one hour under normal conditions. Then, secure with mechanical fixings, as below.
• Drill two holes on each side of the stair nosing, one approximately 15mm in from the back edge and 15mm from the side.
• For larger nosings, it may be necessary to have further fixing points in the centre of the nosing.