floorsaver Warehouse Line Marking Paint is a tough polyurethane paint that is ideal for marking out walkways and hazardous areas in busy warehouses, factories, workshops and more. It can be applied in just one coat using a small brush – two coats may be required on rough, textured or dark substrates. Not only that, it’s a single pack product, which means that once you’re done you can pop the lid back on and reuse for another time. Its available in two colours which create clear, bright and safe line markings.
Just make sure the surface is clean and dry. Remove any loose deposits and dirt with a stiff or wire brush. If applying the paint line to a newly painted floor, the new glossy paint should be lightly sanded.
Step 2 – Application:
Stir the paint thoroughly.
Do not thin.
Apply to the floor using a paint brush. Bare concrete should be sufficiently porous to allow the paint to soak in. For particularly porous, open textured concrete, or if you are overcoating a darker colour, a second application may be required.
Suitable for concrete, asphalt when used as a linemarker, wood and most metals
Coats
One coat application (on most surfaces)
Coverage
2.5L covers up to 20m² per coat, or approximately 150m of 100mm wide line
Drying times
At 15-20 ℃:
Recoat (if you need) - 16 hours (if there is a time lapse between coats, the second coat must be applied within 5 days of the first coat)
Touch Dry - 10 hours
Light Foot Traffic - 24 hours
Full Use - 36 hours. Please check that the paint has fully cured before putting into full use
Applications
Tough enough for line marking warehouses and workshops
Shelf life
Shelf Life - 12 months, if unopened. Do not allow to freeze.
We don't recommend:
Applying to hard, smooth, very dense or power floated concrete where the paint can’t soak into the surface. If in doubt tip a cup of water onto the floor and see if it disappears.
Applying to concrete contaminated with oil, grease, fats or wax.
Painting large areas on asphalt – lines and hazard markings are fine.
